Xemectrum

Please don't dig up dead threads . Let it RIP .

Is this patched?

its patched after v92

hi~ hairy . I saw your Fvac post last two days . I follow all your steps but i still face some problem
please help me if you can~
i will list out my steps so that you can see any mistake that i had made
Steps
1)I open the Harepacker ver3.5
2)after tat,i load the map.wz and find my map id~
3)render my map id and start to change those value
4)the next value n previous value i change it into 0 , example 1 2 3 4 5 6 7 8 . the mob spawn at 2 , 4 , 6 . and i change the next n previous value into 0 for 2 3 4 5 6 7 .(i'm not sure that i'm correct or not)
5)the force value i chg it to 230
6) i tick the Default Next Value: 0 (Tick this for all) Default Force Value: 230 (Tick this for Fvac and edit the value if you are using it at a lower force) as written in your guide because i want the mob move from left to right
7)save the map.wz
8) on my maple
but when i reached the map the gm straight dc me and i notice the mob just stucked at there place
can you tell me where is my mistake?

Non3 wrote:hi~ hairy . I saw your Fvac post last two days . I follow all your steps but i still face some problem
please help me if you can~
i will list out my steps so that you can see any mistake that i had made
Steps
1)I open the Harepacker ver3.5
2)after tat,i load the map.wz and find my map id~
3)render my map id and start to change those value
4)the next value n previous value i change it into 0 , example 1 2 3 4 5 6 7 8 . the mob spawn at 2 , 4 , 6 . and i change the next n previous value into 0 for 2 3 4 5 6 7 .(i'm not sure that i'm correct or not)
5)the force value i chg it to 230
6) i tick the Default Next Value: 0 (Tick this for all) Default Force Value: 230 (Tick this for Fvac and edit the value if you are using it at a lower force) as written in your guide because i want the mob move from left to right
7)save the map.wz
8) on my maple
but when i reached the map the gm straight dc me and i notice the mob just stucked at there place
can you tell me where is my mistake?

It's patched long ago.. Please don't bring up dead post..