Xemectrum

can i give some some suggestion for your 3rd bot(if you are trying to work on the 3rd bot).since u can make an auto move.is it possible that u lock the characther at that position.For example,u are at the foothold 45 and u are knockback by monster to foothold 47, then it auto walk back to foothold 45 again.

well just a little bit of my opinion.Dun mad XD.if cant this NRZBot v2.0 still work fine for me.well nice job nerrazzuri and thx for your bot XD

peter9545 wrote:can i give some some suggestion for your 3rd bot(if you are trying to work on the 3rd bot).since u can make an auto move.is it possible that u lock the characther at that position.For example,u are at the foothold 45 and u are knockback by monster to foothold 47, then it auto walk back to foothold 45 again.

well just a little bit of my opinion.Dun mad XD.if cant this NRZBot v2.0 still work fine for me.well nice job nerrazzuri and thx for your bot XD

Impossible. And that's why my bot doesn't require bypass, if MSEA has a bypass, i could even make a rusher which helps character to go back to town and buy pots. The bots basically doesn't know what happen to MapleStory so too bad I can't help you with this.

Err..i want to ask..

Why when i using heal(cleric skill)..the auto move cannot work? - -

Is there anyway so that i can make it would work/move?

AMDFusion wrote:Err..i want to ask..

Why when i using heal(cleric skill)..the auto move cannot work? - -

Is there anyway so that i can make it would work/move?

put delay in the skill box

I'm a newbie to these things, can i know how this works? I mean i downloaded all the injectors from another post and tried injecting them, a few were detected and the rest had no reaction even after injecting? A guide to injecting would help here, i've looked around a bit as well..

Also if possible, recommend a good injector yourself.

use Winject to inject the dll

Quickly inject it and close the injector so it wouldn't get detected.

HOW TO USE THIS. ALL I GET IS THE .DLL FILE ONLY WHERES THE BOT?

the leecher above me......... FK OFF!!!!!!! READ BEFORE YOU POST ANY THING!!!!!!

For those people doesn't know how to inject a DLL file, Get a injector... I myself using Perx and so far so good...

Get a auto injector 1st. Then load maple and let hack shield run for like 3 sec then open "auto injector". It should work fine.. Don't inject before hackshield load... And pls read before posting useless stuff like "why only dll file? does this need a bypass or how the HELL do i inject".. It not easy for Nerrazzuri to do this so stop stressing him up...




READ BEFORE YOU ASK STUPID QUESTION