Help in cs eax!! ><

[Xiia0dii]

Posted this same question in another post. But no one replied. So..

How to perform a cs eax vac? Do we need a bypass?

This was wat i do,and the maple shuts down.
But when i put the value of the x coordinate only,the whole maple not responding. Any suggestions??

This is wat i've done.
run injector
>boredness trainer
>maplestory
>turn on moonlight engine 5.4
>maple character go to a map
> F10 on boredness trainer
> moonlight engine ct> add address manually (009DE388) > change register here
> maplestory not responding.


Help will be greatly APPRECIATED.

[Original]

You have to make sure that the CE uses the Kernel Mode Debugger.So in simple terms wrong settings.

[iSean]

I'm make a guide now later post it...

[xNewToThis]

Posted this same question in another post. But no one replied. So..

How to perform a cs eax vac? Do we need a bypass?

This was wat i do,and the maple shuts down.
But when i put the value of the x coordinate only,the whole maple not responding. Any suggestions??

This is wat i've done.
run injector
>boredness trainer
>maplestory
>turn on moonlight engine 5.4
>maple character go to a map
> F10 on boredness trainer
> moonlight engine ct> add address manually (009DE388) > change register here
> maplestory not responding.


Help will be greatly APPRECIATED.

same case , your at 64bit? cause olny 32bit can run in kernel mode..

[iSean]

I quited Hercules Due Ban Now... In some Private world.
CS EAX (Register Edits)Permanetly Bans Good Luck ^^

[Xiia0dii]

Posted this same question in another post. But no one replied. So..

How to perform a cs eax vac? Do we need a bypass?

This was wat i do,and the maple shuts down.
But when i put the value of the x coordinate only,the whole maple not responding. Any suggestions??

This is wat i've done.
run injector
>boredness trainer
>maplestory
>turn on moonlight engine 5.4
>maple character go to a map
> F10 on boredness trainer
> moonlight engine ct> add address manually (009DE388) > change register here
> maplestory not responding.




Help will be greatly APPRECIATED.

same case , your at 64bit? cause olny 32bit can run in kernel mode..

Erm i not sure. How to check which 'bit' i have in my com?