Page 1 of 1
Help in cs eax!! ><
Posted: Sat Oct 10, 2009 5:09 pm
by Xiia0dii
Posted this same question in another post. But no one replied. So..
How to perform a cs eax vac? Do we need a bypass?
This was wat i do,and the maple shuts down.
But when i put the value of the x coordinate only,the whole maple not responding. Any suggestions??
This is wat i've done.
run injector
>boredness trainer
>maplestory
>turn on moonlight engine 5.4
>maple character go to a map
> F10 on boredness trainer
> moonlight engine ct> add address manually (009DE388) > change register here
> maplestory not responding.
Help will be greatly APPRECIATED.
Re: Help in cs eax!! ><
Posted: Sat Oct 10, 2009 6:12 pm
by Original
You have to make sure that the CE uses the Kernel Mode Debugger.So in simple terms wrong settings.
Re: Help in cs eax!! ><
Posted: Sat Oct 10, 2009 7:20 pm
by iSean
I'm make a guide now later post it...
Re: Help in cs eax!! ><
Posted: Sun Oct 11, 2009 9:30 am
by xNewToThis
Xiia0dii wrote:Posted this same question in another post. But no one replied. So..
How to perform a cs eax vac? Do we need a bypass?
This was wat i do,and the maple shuts down.
But when i put the value of the x coordinate only,the whole maple not responding. Any suggestions??
This is wat i've done.
run injector
>boredness trainer
>maplestory
>turn on moonlight engine 5.4
>maple character go to a map
> F10 on boredness trainer
> moonlight engine ct> add address manually (009DE388) > change register here
> maplestory not responding.
Help will be greatly APPRECIATED.
same case
, your at 64bit? cause olny 32bit can run in kernel mode..
Re: Help in cs eax!! ><
Posted: Sun Oct 11, 2009 9:44 am
by iSean
I quited Hercules Due Ban Now... In some Private world.
CS EAX (Register Edits)Permanetly Bans Good Luck ^^
Re: Help in cs eax!! ><
Posted: Sun Oct 11, 2009 11:31 am
by Xiia0dii
xNewToThis wrote:Xiia0dii wrote:Posted this same question in another post. But no one replied. So..
How to perform a cs eax vac? Do we need a bypass?
This was wat i do,and the maple shuts down.
But when i put the value of the x coordinate only,the whole maple not responding. Any suggestions??
This is wat i've done.
run injector
>boredness trainer
>maplestory
>turn on moonlight engine 5.4
>maple character go to a map
> F10 on boredness trainer
> moonlight engine ct> add address manually (009DE388) > change register here
> maplestory not responding.
Help will be greatly APPRECIATED.
same case
, your at 64bit? cause olny 32bit can run in kernel mode..
Erm i not sure. How to check which 'bit' i have in my com?